Turning Center Spindle Use 7028AC Ball Bearing 140x240x33mm In Stock

Turning center spindle use 7028AC ball bearing 140x240x33mm in stock

Single row angular contact ball bearings 7028C can only bear the axial load in one direction. When bearing the radial load, it will cause additional axial force, and can only limit the axial displacement of the shaft or shell in one direction. The contact angle of angular contact ball bearing is 40 ,25,15 degrees, so it can bear a large axial load. Angular contact ball bearing is a non-separable design, and the shoulders on both sides of the inner and outer rings vary in height.

The ball bearing 7028AC specification as following:
The bearing full name:single row four point contact ball bearing
The bearing full items:7028AC
The bearing old type:7028c 7028b
Service:offer sample available
Original:Made In China
The bearing clearance:C1 C2 C3 Group
The bearing full inch size:5.51x9.45x1.3 inch size
The bearing outer diameter inch size:9.45
The bearing inner diameter inch size:5.51
The bearing height:1.3 inch size
The bearing boundary size:140X240X33mm
The bearing outerside diameter:240mm
The bearing inside diameter:140mm
The bearing width:33mm
The bearing load :axial and radial load
The bearing accuracy grade:P5 P4 P2 grade

Back to back bearing arrangement
Face to face bearing arrangement
Tandem bearing arrangement
DB:Back-to-back arrangement Designation suffix DB
DF:Designation suffix DB Designation suffix DF (FF)
DT:Tandem arrangement Designation suffix DT (T)
TBT:Back-to-back and tandem arrangement Designation suffix TBT (TD)
TFT:Face-to-face and tandem arrangement Designation suffix TFT (TF)
TT:Tandem arrangement Designation suffix TT (3T)
QBC:Tandem back-to-back arrangement Designation suffix QBC (TDT)
QFC:Tandem face-to-face arrangement Designation suffix QFC (TFT)
QBT:Back-to-back and tandem arrangement Designation suffix QBT (3TD)
QFT:Face-to-face and tandem arrangement Designation suffix QFT (3TF)
QT:Tandem arrangement Designation suffix QT (4T)